Suitable for heavy gauge polythene's, co-extruded and laminated thermoplastic films e.g. Nylon/poly, Polyester/poly, etc.

Available in a range of sizes and has either both jaws or a single jaw heated (depending on application and gauge of film). Pneumatic operation allows the feature of a wide jaw opening. The unit is produced in a form to allow it to be bench/stand mounted or bolt into a overhead frame work if used in a inline system.

The chassis houses all machine mechanisms, pneumatics, electrics and controls. The pneumatic circuit incorporates a low pressure safety system, this allows the sealing jaws close by low pressure only (until fully closed). Should the operator's hands be between the jaws as they close, no harm will become them from either pressure or heat. High air pressure and heat will only operate when the jaws are fully engaged on the film. Controls comprise of an electronic twin timer for both heat and cool cycle's and a regulator for mains air pressure.

Operation is simple by use of an electric foot switch (push button version available on request). Sealing is initiated when jaws are closed on the film, jaws open automatically once the seal cycle is complete.

The standard machine finish is hard wearing powder coat, colour white. Other types of finish e.g stainless steel, galvanised as well as higher levels of ingress protection i.e IP 54/65 versions available.